Install a Mini Tail Servo Controller


Step 1. Obtain or build the following parts; mini tail servo controller, switch harness, button board, servos, battery, charger.

Step 2. Connect the switch harness to the mini tail servo controller, note the polarity on the connector. 

Step 3. Connect the button board to the mini tail servo controller, note the polarity on the connector. 

Step 4. Connect the "Wag Servo" to the mini tail servo controller, note the polarity on the connector.  

Step 5. Connect the "Tuck Servo" to the mini tail servo controller, note the polarity on the connector.  

Step 6. Connect the battery to the switch harness, note the polarity on the connector.  

Step 7. Connect the charger to the switch harness, note the polarity on the connector. 

When the switch is in the off position, the charger will be connected to the battery, (the red LED will light up on the charger, when it is charging.)

When the switch is in the on position, the charger will be disconnected and the mini tail servo controller will be powered.

Note: you can also just plug the battery into the charger.

You are now ready to program a mini tail servo controller.


More How To